
Built by Platinum Finishing Systems (PFS). Air enters through a full ceiling plenum and is pulled straight down through a full-length grated floor — the cleanest airflow we build for show-quality truck and coach finishes. Install it over a pit or on a raised basement floor. ETL listed (Intertek) for the USA and Canada, NFPA 33 compliant, made in the USA. Ships nationally.


Full ceiling plenum intake with exhaust through a full-length grated floor. Overspray is pulled straight down and away from the vehicle. The booth can be built over a concrete pit or as a raised basement on your existing slab. Optional natural gas or electric heat, an air make-up unit with humidity control, and spray and bake (cure) can be added.
PFS paint and spray booths are ETL listed by Intertek for flammable and combustible applications in the USA and Canada (cETLus). Control panels are UL 508A, including hazardous-location panels. Booths are built to NFPA 33, the IBC, and the NEC. Fire protection is dry chemical (Amerex, Pyro-Chem, or Stat-X) or sprinklers. PFS builds its own air make-up units.
Tap any photo to open it full size.
At least 16 ft W x 50 ft L x 14 ft H, with longer booths when the tractor and trailer stay together.
Typical working size is 14-16 ft W x 40-60 ft L x 12-14 ft H, with drive-through when you want a straight path through the shop.
Full downdraft is the truck airflow to choose when finish quality comes first and the site can take a pit or a raised basement floor.
| Application | Typical working size |
|---|---|
| Class 8 tractor (semi-truck) | At least 16 ft W × 50 ft L × 14 ft H |
| Tractor and trailer together | 16–18 ft W × 60–80 ft L |
| Transit, school and motor coaches | 14–16 ft W × 40–60 ft L × 12–14 ft H |
| Larger equipment and custom builds | 20 × 14 × 40, 24 × 16 × 50, 30 × 18 × 60 ft and beyond |
Custom widths, heights and lengths are available. These ranges are the starting point Platinum Finishing Systems (PFS) uses on the truck and fleet hub — not a catalog of stock SKUs.
Tap a topic to open it. Tap again to close.
A Class 8 tractor needs at least 16 ft W x 50 ft L x 14 ft H. A tractor and trailer together usually wants 16-18 ft W x 60-80 ft L. Transit, school and motor coaches typically run 14-16 ft W x 40-60 ft L x 12-14 ft H. Larger equipment can be built to 20 x 14 x 40, 24 x 16 x 50, 30 x 18 x 60 ft and beyond.
Drive-through doors at both ends are available on PFS full downdraft truck booths, so tractors and coaches can pull straight through instead of backing out.
Full downdraft is the only PFS truck airflow that needs a pit or a raised basement floor. If the slab can be opened, a concrete pit is poured to PFS-supplied dimensions and the finished floor sits flush with the shop. If you cannot cut the slab — a leased building, a retrofit, or a short downtime window — a raised basement full downdraft sits on the existing floor. Vehicles roll in over a short drive-on ramp. Ceiling height must allow for the raised floor and the exhaust stack. For the airflow idea without truck sizing, see the raised-basement and full downdraft pages.
A PFS truck booth can optionally be built as a heated truck paint booth with natural gas (gas-fired) or electric heat, and can run spray and bake (cure) cycles on the PFS Core Control Panel (spray, flash and cure modes). Pair the booth with a PFS air make-up unit when you need tempered replacement air; humidity control is available on the AMU. Heat can also be configured for propane where the site has no natural gas. A heated AMU may be direct- or indirect-fired and is sized to the booth exhaust.
PFS truck booths ship ETL listed (Intertek) for the USA and Canada, with UL 508A panels, and are built to NFPA 33. We supply the drawings and data your permit packet needs.
Send the largest vehicle dimensions; door type (drive-through or single-entry); shop footprint and ceiling height; pit or raised basement; coatings; and whether you want heat, an air make-up unit, or spray and bake. Photos of the bay help us spec faster.
Quote in 24 hours. Made in the USA with ETL listed components. Installed nationwide.
See related installs at American Event Services in Danville, IL and Mustang CAT in Hempstead, TX.

Oversized spray booths for semi trucks, buses, fleet vehicles, and large equipment.

Front ceiling intake and rear floor exhaust, no pit. A step up from crossflow.
The standard enclosed PFS full downdraft line — ceiling intake, grated-floor exhaust.

Tempered make-up air systems to replace exhausted air and maintain positive booth pressure.