PAINT BOOTHS — OPEN FACE
Cross-draft airflow. ETL listed (Intertek) for the USA and Canada. Manufactured in the USA. UL 508A controls. Built to NFPA 33 standards. Available in standard and custom widths. Open front access for large parts and assemblies.
Air enters freely through the open front and exits through exhaust filters on the rear wall — horizontal cross-draft airflow pulls overspray away from the operator at all times.
Select a width and height — available depths appear below. Custom sizes available on request.
Custom widths, heights, and depths available. We engineer to your facility requirements.
Add a direct-fired or indirect-fired heat system to your open face booth for accelerated cure times. Blanket intake filter upgrades included with all heated configurations.
Maximize throughput and compliance by pairing your open face booth with a dedicated mixing room for paint prep and an AMU for tempered make-up air.
Tap any photo to open it full size.
A spray booth with an open front and a filtered exhaust wall at the back. Air enters through the open front and carries overspray away from the painter into the filters.
For large or awkward parts, frequent loading and unloading, and work that does not need a dust-free enclosed environment, such as industrial parts, wood and general fabrication.
Open face booths cost less and give easy access. Enclosed booths control dust and air better and support heated cure, which matters for vehicles and high-gloss finishes.
Yes. PFS open face booths are ETL listed (Intertek) for the USA and Canada and built to NFPA 33 with UL 508A controls.
Standard and custom widths, heights and depths to fit your parts and floor space.
Need replacement filters for this booth? PFS Filters stocks intake, exhaust, ceiling, and prefilter media for paint booth maintenance.
